Re: ih 350u clutch adj

Posted by Janicholson on June 11, 2007 at 07:10:17 from (71.87.39.51):

In Reply to: ih 350u clutch adj posted by lester350u on June 10, 2007 at 18:07:49:

Did you check the depth of the flywheel from the PP mount flange to the friction surface. this must be within .010" of spec.
Did you check the disk for out of round, or runout, by putting it on the trans shaft, and spinning it to check??
The finger adjustment is most important that it be even in depth from a commom point. not in terms of a specific height. they need to be within .005" of the same installed height, when in place with the bolts tight.

Ive been thinking on your issue, and things don't seem correct with some component in that assembly. Idon't rule out pivot point slop in the pedal, or linkage greif, but that change in the finger height from stopped to high idle bothers me. Is there adifference between the old and new PP? trying to help, JimN

Replies:

• Re: ih 350u clutch adj lester350u 17:04:31 06/11/07 (1)
  • Re: ih 350u clutch adj Janicholson 20:29:28 06/11/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]