|
Farmall & IHC Tractors Discussion Board |
Re: M clutch blew
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob Kerr on May 25, 2007 at 05:44:11 from (205.188.116.138):
In Reply to: Re: M clutch blew posted by BF8690 on May 24, 2007 at 14:06:18:
I guess I am worried about leaving it sit there where it is as I will have to leave it half tore apart possibly for a day or two at a time. it is pointed up hill, but only 50 feet to the rear is a good size pond and the deepest part of the pond. No one lives there and once in a while we get some bozo from the state forest come through on a 4 wheeler and I would hate to see them move the log blocking it, release the brake and roll her down to Davy Jones locker. Dad owns the place but lives in Indy, and I live 40 miles west of his woods. I did have a nice drive on the ol M taking it over there last Monday. took about 3hrs 45 min to get there and lot of pretty country in between.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|