|
Farmall & IHC Tractors Discussion Board |
Re: Super A rear control arm
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on May 03, 2007 at 09:33:32 from (4.227.105.29):
In Reply to: Super A rear control arm posted by scotty on May 03, 2007 at 08:18:19:
If you have the original arm on there and not one from another tractor then I might be able to help some. The spring is about 2 3/4 inches long and has a gap of about 1 1/4. I looked and looked for one and ended up getting a compression spring from Fastenal. The gauge and length were right but the opening was a little to small. I heated it up and bent it open some then stuck it on a 1" water pipe and just beat it til it was back straight and loked right. The part number was 110166728. There are two in the bag so if you mess up one theres always a spare. Cost $5.85. #54 compression spring. 
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractors and the City Boy - by Ken. A few years back I came to the conclusion that city life wasn�t for me. The houses so close together you could hear the neighbors fight, traffic so heavy speed limit signs meant nothing. So I started looking for the ultimate country setting. After many months I found the perfect place, off the beaten path, up a private � mile drive, old stone house which has stood the test of time, out buildings which haven�t stood the test of time, trees, birds, rabbits, and snakes. This is the place! Bought
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
