|
Farmall & IHC Tractors Discussion Board |
IH 300 utility ...PTO Questions/Interchangeability
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ben in OH on April 15, 2007 at 09:14:24 from (71.2.200.221):
Hi everyone, New to Forum. I recently purchased an IH 300 Utility tractor with a loader, fast hitch 3-point, and scraper blade. I would like to put a PTO unit on it and have found one off a farmall 450 gas which I may be able to pick up for cheap, but I will have to travel a ways to pick it up. Does anyone know if it will bolt up on my utility? I cant seem to get the local dealer to help me, But I,ve been told that even if its the same unit, it would have a different handle. could I possibly fab a handle up to make it work for my tractor? Im pretty handy with this sort of thing, but it would be nice to see one first. Also, a tractor boneyard near here has a PTO unit that will fit, but its missing the handle, and is much more expensive. Thanks in advance, any info greatly appreciated.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|