1066 Hyd Clutch-Hey Owen AaLand

Posted by Michael Sheik on April 04, 2007 at 19:02:41 from (65.255.65.229):

I just took a look at the holes in the two pins and both were filled with dirt and rust. Dug them out with small screwdriver and it looks like a quarter inch hole on both and looks like both have threads. I think tomorrow on my day off I will construct a little slide hammer assy to try to pull the pins. If my hammer is a success, I will take a picture and post it.

On the leak on the fitting on the MCV, it is the fitting above the one I was looking at and the one you pointed out. I am going to try to wrench it a little in the morning. If it doesn't move, it looks hard to pull. Oring here or what?

Replies:

• Re: 1066 Hyd Clutch-Hey Owen AaLand the tractor vet 09:47:10 04/05/07 (0)
• Re: 1066 Hyd Clutch-Hey Owen AaLand Owen Aaland 19:22:29 04/04/07 (0)
• Re: 1066 Hyd Clutch-Hey Owen AaLand Janicholson 19:17:56 04/04/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]