Re: Cant get H to run

Posted by riverbend on March 31, 2007 at 07:13:05 from (208.160.34.246):

In Reply to: Re: Cant get H to run posted by eshoreboy on March 30, 2007 at 20:14:32:

Nope.

You might have to take the valve cover off and crank the motor to be sure that you are at TDC on #1 cylinder's firing stroke. You will see the exhaust open and close, the intake open and close, and both rockers will be a little loose. The timing mark will line up with the pointer, and the mag rotor should point to the #1 plug wire.

The other case is that you are choking it too much. On your first try to start it, leave the ignition off, pull the choke rod all the way out, and give it two cranks. Push the choke all the way in, open the throttle 6 or 7 clicks, turn the ignition on, and crank it over.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]