Farmall & IHC Tractors Discussion Board |
Re: Removing steering gear on a M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by HENRY E NC on March 24, 2007 at 17:58:05 from (216.119.7.107):
In Reply to: Removing steering gear on a M posted by Jason Mortzheim on March 24, 2007 at 17:36:32:
I tried most everything iincluding a puller made especially for that purpose and jacking front end up and using a splitting wedge etc. Finally had to use heat on the gear, a new nut and lots of sledge. Never again. Why do you want to remove it for painting, I painted mimne after it was all back together. The only reason to take the gear off is to chage the gear or replace the busings in the bolster . I changed to busings and rotateed the gear 180 and fixed my steering problems.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|