Re: 350 u will not move

Posted by Owen Aaland on March 20, 2007 at 23:16:12 from (65.165.246.14):

In Reply to: 350 u will not move posted by Trent DeRudder on March 20, 2007 at 20:47:44:

The growling in low TA position may be an indication of the problem. The pinion gears and bearings are the only additional parts moving while in TA rather than direct drive position. Direct drive is accomplised by locking the TA carrier with the pinion gears to the TA input shaft which in turn drives the transmission input shaft all as one unit. A failure of the pinion gears or either shaft gear will cause a condition of no drive through the TA in either position of the lever.

Remove the TA clutch inspection cover and see if the TA clutch is turning when the engine clutch is engaged. That should allow you to determine if the problem is in the TA or engine clutch.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]