Re: Farmall A Zenith Carb questions

Posted by CNKS on March 07, 2007 at 19:13:37 from (204.249.178.32):

In Reply to: Farmall A Zenith Carb questions posted by Chad from Michigan on March 07, 2007 at 06:24:28:

The screw is for the idle, the main jet is fixed unless you happen to have a kerosene/distillate carb. The float setting is 1 5/32 not 1 5/16, according to the A service manual. The measurement is with the top of the carb upside down, measured from the gasket to the top (with it upside down) of the float. As El Toro said, that carb will usually run rich unless you work the tractor hard, you might need to lower the setting, but that won't affect performance, unless it is way off. You really should replace the needle and seat. But, if you are SURE your carb is clean, then you have a piece of rust of something restricting the flow, most likely in the outlet of the gas tank before it gets to the sediment bowl.

Replies:

• Re: Farmall A Zenith Carb questions CNKS 19:18:06 03/07/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]