|
Farmall & IHC Tractors Discussion Board |
Re: Help idenitfying tranny gears...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on February 22, 2007 at 14:02:28 from (70.226.20.153):
In Reply to: Re: Help idenitfying tranny gears... posted by Janicholson on February 22, 2007 at 13:33:24:
Not worrying. If one gear goes out, I have 4 others!! hehe. 4th is used the least, so I'm not worrying. It's just nice to know if you are a mile from disaster that could take out more with it, or a few inches from just a lost gear. Its a good thing, cause I dont wanna take the clutch cover off again it was a PITA to get that plate formed back to the contours and to make a new gasket for it.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
