Farmall & IHC Tractors Discussion Board |
checking compression on Super C ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul Shuler on January 16, 2002 at 11:44:23 from (152.163.197.206):
I tried to check the comp. on my old Super C today. Don't know if I did it right. My father in law had an old gauge he had since the 60's so thought I would give it a try. This gauge did not screw in, it has like a rubber stopper on the end you have to hold in the spark plug hole.Had my dad turn the hand crank while I tried to hold this thing over the hole without looseing to much air.It read around 50psi on all the cyl.s. Is that posible it could be that low and still seem to run as well as it does. It does not smoke at all or seem to use any oil. It does have a bad rear main oil leak. Should I get it checked by a more reliable method? I plan on splitting it when it gets a little warmer to repair oil leak, should I plan on a rebuild at that time? Thanks, Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|