|
Farmall & IHC Tractors Discussion Board |
Re: Farmall M - MW Nine Speed Gear Set
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny Frisk on January 15, 2002 at 08:46:42 from (12.4.181.2):
In Reply to: Farmall M - MW Nine Speed Gear Set posted by lcbateman on January 15, 2002 at 07:23:46:
I've got an M&W parts sheet on their 9-speed package. The unit replaces the constant mesh gears at the very front of the transmission and the input shaft. The new constant mesh gears are narrower because there are 2 of them. The shifter mechanism is on the lower gear. You have to completely dissassemble the transmission because Your replacing the the bottom shaft and the front top shaft ahead of the pilot bearing. The transmission top cover has to be removed. M&W as of about 1983 when I got this parts sheet from them no longer sold the 9-speed kits anymore but did have some parts available, and I understand some are still avail. today.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|