|
Farmall & IHC Tractors Discussion Board |
Re: Single Pole Alternator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on December 24, 2001 at 06:05:15 from (129.37.117.155):
In Reply to: Single Pole Alternator posted by Marlin Mangels on December 24, 2001 at 04:44:11:
The alternator has to turn at a fairly high rpm to start charging. Once started, it will continue to charge at lower RPMs. Since these tractors run at low rpm as compared to a car engine, the alternators sometimes have this problem on an old tractor. I have two tractors with this problem, and I have to pull back the throttle linkage to the carburator to race the engine to get the charging started. I have to do this each time I start the things. Unfortunately, I think the linkage to the carb on the M is closed, so not so easy to do this. If you have not already done so, you need to get the smallest possible pulley for your alternator to make it turn as fast as possible. That will help. Others here on the Forum may have othe suggestions. I had not heard about the cut out switch mentioned by OhioBill. Wonder if all the one wire alternators have that, and how do you change it.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|