|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: One HOT A !!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by EZHangin on December 03, 2001 at 17:34:03 from (216.211.32.2):
In Reply to: Re: Re: One HOT A !!! posted by F14 on December 03, 2001 at 17:04:40:
I did make an adjustment to the carb float as it was set way too low and causing the valve to stick. i.e. no gas going in to float bowl. If I turn the carb upside down the floats are set at level , just under 1/4".
Also, thinking toward gov. because of the way the engine sounded better when I manually held the throttle lever right at the carb. I sure hope I did not forget to put something back in the gov. when I put it back on. I was careful not to remove the weights, bushing , etc... in fact I covered them with a plastic bag and left it alone (on the tractor) while I painted the body of the gov.
Do you agree the high revving caused the over-heat? I would say 15 minutes running time , and certainly no more than 20.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
