|
Farmall & IHC Tractors Discussion Board |
Re: Need help with Super M distributor please
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on November 30, 2001 at 20:31:06 from (216.196.13.73):
In Reply to: Need help with Super M distributor please posted by R.H. on November 29, 2001 at 19:19:18:
My self i would go with the one that is marked with the 25 degree plate and set the timing at no more then 5 degrees that will give you a total of 30 degrees at full throttel and see how it hangs on under full load you might have to back it down to top dead center if it won't lug. The 25 degree plate was a up date for power packs the old M use to run a 40 degree plate but lost lugging with the that much timing. I set up a lot of dist. around here since i have one of the last Dist.strobe left in my area.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|