Farmall & IHC Tractors Discussion Board |
Re: Super C front castings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FC on October 19, 2001 at 07:28:36 from (208.14.16.15):
In Reply to: Super C front castings posted by J. D. Humm on October 18, 2001 at 16:31:08:
Reminds me of when my dad warned me of the same thing as a kid. Often spring rains would "wash out" some pretty good ditches in the fields, and then when mowing thick hay with the C you did not see a large ravine until you were already in and out with the front. Many times I have dropped the tricycle front of my C into a very deep ditch in 3rd gear at full throttle. I still wonder how it survived. Even more recently I was brush hogging and dropped it into a ground hog hole. These are another issue in this area. About the only advice is to slow down in areas you are not familiar or may have these type hazards.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|