|
Farmall & IHC Tractors Discussion Board |
C Oil Filter Troubles-Help Please
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave K on October 09, 2001 at 17:34:03 from (204.180.61.83):
While changing the oil and filter on my C, the new
filter came with a gasket and there did not seem to be any gasket under the metal shell when I took it off. I installed the gasket and it leaked, I took the gasket out and it leaked, I tightened the retaining screw just that last little bit and it broke. Two questions:
1. Where can I get a replacement bolt. I am sure I am not the first person to be this dense. 2. What about the gasket? The groove on the base seems to be "v" shaped as though to contact both sides of the can. The gasket was square in profile. Is there a gasket here? I presume I can get the broken screw out easily since it has a hole down the center. Any advice on this is also appreciated. Thanks in advance- Dave
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
