Re: Calling H magneto Experts - Hey Red!

Posted by Farmer Bob on September 13, 2001 at 22:09:45 from (208.49.9.220):

In Reply to: Calling H magneto Experts - Hey Red! posted by BTD on September 13, 2001 at 11:11:24:

BTD, (Check your email) I'm no expert but...you probably have an H-4 Mag on that H and it is a clockwise mag. Ensure you have the "R" on the distributor spindle lined up with the chamfered tooth on the rotor gear pinion gear. (If it was a Counter-clockwise mag you would line up the "L" on the spindle with the chamfered tooth on the rotor gear pinion). If you have an older version of the H-4 you may not have the round bakelight with the "R" & "L" on the spindle. In this case there will be two teeth on the distributor spindle that have their ends partially cut off at an angle. If this is your type of spindle, set the two marked teeth staddle of the one marked tooth on the rotor gear pinion.

The H-4 mag with clockwise rotation was used on the A, B, U-2, H, W-4, I-4, O-4, U-4, IU-4, M, W-6, I-6, O-6, U-6, IU-6, and T-6. These mags had serial #'s H4-xxx,xxx and had a spark range of 35 degrees.//FB

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Calling H magneto Experts - Hey Red! Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]