Farmall & IHC Tractors Discussion Board |
Re: Speeds on a cub
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on September 03, 2001 at 18:04:35 from (208.49.9.248):
In Reply to: Speeds on a cub posted by Jon D on September 03, 2001 at 17:42:09:
Jon, I don't agree or disagree with you but if your Mom wants to spread horse doo at the rate that full throttle in second gives her, she probably knows what she's doing. It may not be the same if she traveled in third and reduced throttle. Besides, in second and high rev's she is warming that little cub up good to get rid of all that condensation that tends to build up inside the engine. Unless you have a whole squadron of horses I suspect she only has to do the doo chores once a month at most. I ask, do you load the spreader for her? Be glad that your mom is able and knows how to drive the little cubby with the doo spreader in tow. You're right, you will never win an argument with your mom!//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|