Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: RE: Farmall H clutch pilot bearing lubrication
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Slappy on August 31, 2001 at 05:40:14 from (143.88.58.77):
In Reply to: Re: Re: Re: RE: Farmall H clutch pilot bearing lubrication posted by The Red on August 31, 2001 at 05:14:57:
Red, I have lined the pointer up with the single mark, double mark and every point in between several times, and I can't find any fitting at all. I even had a friend of mine turn the engine while I inspected it with a flashlight and again while I ran my finger over the flywheel edge - nothing. Is it possible that someone replaced the flywheel with a part from a different model that did not have a grease fitting? What do you think the possible effects will be if I can't grease the pilot bearing? I'm not sure what kind of a job it would be to replace the flywheel, but to an upstart like me it seems formidable.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|