Re: M governor rebuild

Posted by Theman on July 30, 2001 at 05:13:39 from (12.19.86.5):

In Reply to: M governor rebuild posted by jiM on July 29, 2001 at 08:23:40:

Along with checking for wear, make sure nothing inside your governor is binding. I just rebuilt one for an H that had been sitting for some time and was very rusty inside. The shaft that the two needle bearings run on needed to be polished. As The Red said, make sure the thrust bearing is in good shape and slides back and forth freely on the main shaft. It might be a good time to change all of the bearings in your governor. I found them at my local Motion Industries branch (no sales pitch here). Prices are very reasonable and I only had to wait one day for the one (large one w/snap ring) that wasn't on their shelf.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: M governor rebuild Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]