|
Farmall & IHC Tractors Discussion Board |
Re: Re: Camber or caster
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on July 03, 2001 at 07:13:54 from (38.31.74.103):
In Reply to: Re: Camber or caster posted by RAW in IA on July 03, 2001 at 06:44:32:
I agree. With wide front ends, the centerline of the pivot goes throught the tire contact point on the ground. On old trucks, you could see the kingpins angled so the center of pivot was in the tire footprint. It is still there with ball joints wut harder to see. Caster refers to the center of the footprint being behind the center of pivot, just like a caster on a table, pull the tractor forward and the wheels will straighten up. Add toe-in and alignment is complete.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
