Parts source for a Rockwell model 31-325 sander

Thanks..
Bill

The bearing on the grinder will easily press fit into the coupler center. I can supply pics and further answer questions if requested.

1 Cut 1/2" on each side of the center of the coupler. This is your pulley.

2 Save the 2 waste pieces for later.

3 Stack washers on workbench approx. 3/8" high and set your pulley over the washers.

4 Carefully press and tap bearing into coupler until setting squarely on the washers.

5 Cut 1 inch out of each scrap piece so that it will fit inside your pulley when squeezed.

6 Clean and glue the scraps on each side of bearing to keep pulley from coming off bearing while running.

7. Make sure your machine is unplugged then install your pulley on the grinder, replace sanding belt and hand turn watching for any signs of wobble. If none reinstall guards and try it out.

-Steve

Link
s/DeltaIndex.htm

John is right, Delta will be able to supply a parts diagram (exploded views with part numbers), no matter how old it is if you have a model number. They can probably supply the part you need. If not, sign up at Yahoo clubs (yahooclubs.com I think, it's free and you won't get junk email) and find a club called oldwwmachines. Post on there and you'll find the part you need. I just found an internal gear for a Delta/Milwaukee wood/metal bandsaw that I had been looking for for over nine years till I found someone there. Unbelieveable!

Tools

I went there and pasted the address into the notepad and copied it here, should work. Can't remember if I was very clear, but, as I found out the hard way, there is Yahoo clubs AND Yahoo groups, and they don't seem to link up in any way. Let me know if this doesn't work.

Link

Tools