Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

Tractor Pulling Discussion Forum

ring end gap?

Welcome Guest, Log in or Register
Author 
family traditio

01-05-2006 08:19:38




Report to Moderator

what does the ring end gap need to be set at on a U Moline?




[Log in to Reply]   [No Email]
Cody

01-05-2006 12:44:22




Report to Moderator
 Re: ring end gap? in reply to family tradition, 01-05-2006 08:19:38  
If I'm not mistaken, the general rule of thumb is .004 of gap per inch of bore. So 5in bore would have a .20 ring eng gap.



[Log in to Reply]  [No Email]
TAH

01-05-2006 11:22:46




Report to Moderator
 Re: ring end gap? in reply to family tradition, 01-05-2006 08:19:38  
ABOUT AN INCH WOULD DO IT. NEED ANY MORE HELP JUST EMAIL ME AT. WWW.INYOURCLASS.COM



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy