TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

Minneapolis Moline Tractors Discussion Forum

GTB Engine Bolt Torque

Welcome Guest, Log in or Register

Author

Fran

03-02-2004 17:59:37

Report to Moderator

Could someone tell me what I should torque the main, rods and head bolts to on a GTB gas. I have books for all the newer ones but not this tractor. Gotta get the pan on tomorrow. Thanks in advance.

[Log in to Reply] [No Email]

Steve

03-02-2004 21:53:24

Report to Moderator

Re: GTB Engine Bolt Torque in reply to Fran, 03-02-2004 17:59:37

RODS 80-85

MAINS FRONT 110-120
MAINS CENTER & REAR 75-80

WHEN REINSTALLING CYL HEAD TIGHTEN WATER AND INLET AND EXHAUST MANIFLODS BEFORE TIGHTENING CYL BLOCK AND HEAD HOLD DOWN NUTS. ON TIGHTEN HEAD TO A TORQUE OF APPROX 115-120 FT-LBS ON THE CAMSHAFT SIDE AND 95-100 FT-LBS ON THE EXHAUST MANIFOLD SIDE.

[Log in to Reply] [No Email]

Fran

03-03-2004 12:11:17

Report to Moderator

Re: Re: GTB Engine Bolt Torque in reply to Steve, 03-02-2004 21:53:24

Thanks Steve: I'll try it your way on the heads. Is that to get a better alignment on those manifolds? I know we always used to torque the heads before putting any manifolds on other than the upper water one.

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy