I just want to make sure I have the spots right for the oil and water sensors. The sensors have been long since disconnected, and the gages are all rusted and blank. I am planning on picking up a cheap set of water/oil/volt gages just so I have some idea of what is going on. Just to make sure, the oil sensor goes in where the little brass plug is on the mid/left side here:>Link and>Link the water temp probe goes here:>Link The volt meter is going to get attached somewhere on the ign key, I am going to have to get some water tight switches and wire up the head lamps as well :) It's looking good so far, I got the rear brakes working, they were not adjusted, and full of oil. I am going to see how long they last and might get new seals depending. I just put new tires on the front and I have most of the stuff ready to flush out the hydraulic system, and a few new filters. The plan is the backhoe goes into work in about 2 weeks starting the shop foundation :) Thanks!
~Brian
| 
