Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

Massey Harris & Massey Ferguson Tractors Discussion Forum
:

massey 44 zenith carb

Welcome Guest, Log in or Register
Author 
john z

03-29-2005 10:28:50




Report to Moderator

hello everyone. I was just wondering if anybody can help me with initial adjustments on a zenith carb on a 44 after rebuild. and then i was wondering the proper way to fine tune it after it is running. thank you in advance




[Log in to Reply]   [No Email]
Bruce C

03-29-2005 17:13:05




Report to Moderator
 Re: massey 44 zenith carb in reply to john z, 03-29-2005 10:28:50  
If you send me your e-mail address I will e-mail you the setting instructions from the manual I have for my MH44.



[Log in to Reply]  [No Email]
the preacher

03-30-2005 17:41:40




Report to Moderator
 Re: massey 44 zenith carb in reply to Bruce C, 03-29-2005 17:13:05  
the initial settings are 1/2-5/8 turn on the idle screw, and 3-31/2 turns on the main adjustment screw. on my 44, i found that it ran best with the idle screw about 1/4 turn out, and 31/2 turns on the main screw. it runs kinda crappy when cold, but clears up when warm. and watch your timing. too much will cause it to backfire intermittantly, and will cost you horsepower. hope this helps



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy