Egad - Loose parts MF65-please help to identify.

On it were two broken gear teeth, and to Washers/Spacers. The gear teeth I identified as part of a former starter. My starter had a "rebuilt" sticker on it and the teeth matched the spindle perfectly.

The other two parts I am having trouble identifying. The are the same and look like either washers or spacers, bearing spacers perhaps?

They are bright metal rings, 3/16 to 1/8 thick. O.D. is about 1" and i.d about 3/4 to 5/8. leaving the face radius of 1/8 to 3/16.

I appologize that I do not have more accurate measurements. But do you have an Idea what these could be? Again they were found in the clutch cavity.

Jeff

I too, first thought it might be a pressure spring washer from the clutch. However, the clutch seems to work fine. Also, a check of the parts book last night showed that the pressure spring washers are 7/8 O.D. 35/64 I.D. and 3/32 thick.

I measured the part this morning and it is O.D. = .780" ~ 25/32"
I.D. = .565" ~ 9/16"
Thick= .063" ~ 1/16"

Obviously smaller than the clutch spring. I came to a similar conclusion that it must be a "Drive Pinion Stop" PN 1024206M1 from the starter. The only concern I had was the IPM only showed one of these thrust washers in the tip of the starter. However, I am relieved to know that the probable source is from a previous (and now fixed) failure.

It is a blessing that people such as yourselves know these systems so well that you could provide the two sources of these parts from my vague description. Thanks....

Jeff