JD 301AG tune-up specs?

Valves � per 1000 hrs. Engine can be hot or cold. Intake 0.014 in (0.36 mm), Exhaust 0.022 in (0.56 mm)

(if you have a diesel, intake same, exhaust 0.018 in (0.46 mm))

Spark plug gap: 0.025 in (0.6 mm)

Point gap: 0.020 in (0.5 mm)

Timing (w/timing light): connect to #1 (front) plug, at 2500 rpm the S mark on the crank pulley should line up with mark on engine casting

Idle speed: 600 rpm

Idle mixture: screw at top rear of carb, adjust so that will idle smoothly at 600 rpm

High speed adjustment: needle is at bottom rear sticking out of the solenoid housing. At full throttle, turn screw in until engine starts to falter. Then turn out until engine begins to run smoothly. Screw out one more turn. Check under load and adjust if necessary. In very cold weather, it is advised to open screw an additional � - � turn.