|
BigDiesel: I hate to advise someone on how much a tractor is worth, because what it's worth to me will most likely be a different sum to you. That said, probably eveyone knows by now that I'm rebuilding my dad's 70D, which is not all that far removed from your "R". It was parked outside for ten years, then inside for ten years, but after new filters and fuel, it started on the first turn and a half and ran great. I fed the pony a new distributor for $200, and a crab kit for $50, then began to fix all the little things that had been broken over the years of use and neglect. Now....I ran it from July to December, and it continued to drizzle oil out of the stack, and it wasn't getting any better, so I decided to tear it down in December to fix it right. Pits in both cylinders, worn out rings, valves that had held back water, 7,000 hours total time on engine. I've probably not looked for the best deals in service, and I've bought mostly JD brand parts, but I'm still amazed at how much I've spent on it to date, and it's not running or fully painted yet. $300 on new valves/guides/springs, $550 on re-bore and head work, $700 for pistons/rings/rod bearings, $150 for wrist pins bushings and installation, and coming up is $300 for pump and injector overhaul. This doesn't count all the seals, gaskets, paint, bearings, fasteners, governor parts, pony overhaul parts, etc. You could safely add another $1200-1500 to what I listed, and I haven't yet bought tires. Add to this the lack of (I've heard) "R" pistons forcing sleeving, and you'll see, it's probably better to buy one running that you can diagnose, clean-up, and use, than to buy one that is stuck. When they're sitting still, all sorts of other things go wrong. That's why so many stuck ones end up being parted. There's probably more value in it that way. But this one is my sentimental family tractor, so the cost factor gets accommodated quite a bit. I just hope my wife doesn't read this post ! Name-withheld-on-request :) 70D // 855
|