Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

John Deere Tractors Discussion Forum
:

24V JD 4020 diesel starter problems.

Welcome Guest, Log in or Register
Author 
IH 301

04-07-2009 08:29:59




Report to Moderator

I'm currently working on getting a 4020 diesel running. Problem I am having is when I turn the key to crank the engine, the starter turns the motor over great, but when I let off the key, the starter keeps cranking. I have put a new solenoid on the starter with minimal success. I have tried, while the starter is cranking continuously, removing the wire that connects to the S post on the solenoid, and it still cranks the engine over. I'm completly lost on this being I'm new to the 24 volt concept. Any thoughts/opinions is greatly appreciated!!

[Log in to Reply]   [No Email]
Handsome Jim

04-18-2009 14:28:58




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to IH 301, 04-07-2009 08:29:59  
Pull start



[Log in to Reply]  [No Email]
Tom 43

04-07-2009 09:51:54




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to IH 301, 04-07-2009 08:29:59  
Be sure the batteries are up and load test okay. Low voltage can cause high current draw that will weld the solenoid contacts together.



[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:28:19




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to Tom 43, 04-07-2009 09:51:54  
I like your style on KL



[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:28:18




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to Tom 43, 04-07-2009 09:51:54  
I like your style on KL



[Log in to Reply]  [No Email]
IH 301

04-07-2009 11:16:17




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to Tom 43, 04-07-2009 09:51:54  
I looked at a diagram and the batteries are hooked up correctly. One battery had a bad cell so I replaced that with a new one. The other has good charge and is in good shape when load tested.



[Log in to Reply]  [No Email]
dieseldoc

04-07-2009 09:34:36




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to IH 301, 04-07-2009 08:29:59  
hope you get it fixed. My sister burned up my 4430 cause starter stuck on and she didnt know it. kept running it and got so hot it caught wires on fire. it was kind of funny at the time until i had to rewire it.



[Log in to Reply]  [No Email]
ET

04-07-2009 09:23:57




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to IH 301, 04-07-2009 08:29:59  
Check the stop ring for the bendix on the armature just inside the nose cone. If it broke and the bendix throws to far the solenoid won't release.



[Log in to Reply]  [No Email]
jdemaris

04-07-2009 09:43:10




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to ET, 04-07-2009 09:23:57  
Yes, it was the most common failure spot on all the Delcos on Deere diesels. Had to replace many an armature after the ring-groove for that three-piece stop assembly got hammered out.



[Log in to Reply]  [No Email]
buickanddeere

04-07-2009 08:49:16




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to IH 301, 04-07-2009 08:29:59  
Is it the correct 24V isolated chassis solenoid?Did the problem exist before changing the solenoid?



[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:27:34




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to buickanddeere, 04-07-2009 08:49:16  
give up being snotty?



[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:27:33




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to buickanddeere, 04-07-2009 08:49:16  
give up being snotty?



[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:27:32




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to buickanddeere, 04-07-2009 08:49:16  
give up being snotty?



[Log in to Reply]  [No Email]
IH 301

04-07-2009 11:14:36




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to buickanddeere, 04-07-2009 08:49:16  
Before I tore the tractor down to overhaul the motor, it didn't show any of the problems that I am having now. I replaced the solenoid because when I took it apart it had burn spots on it. The day I picked the tractor up from the owner's place, the batteries were low, and the owner hooked up jumper cables to a skid steer to jump start the tractor. I believe this was the cause of the solenoid being burnt. After replacing the solenoid, I can now hook the battery cables up without it sparking and the key now works when I crank the motor.

[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:26:56




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to IH 301, 04-07-2009 11:14:36  
you did not



[Log in to Reply]  [No Email]
WTW

04-07-2009 08:44:21




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to IH 301, 04-07-2009 08:29:59  
Sounds like your problem is mechanical not electrical. If starter still cranks after removing the yellow wire from the "S" terminal it is a mechanical problem. Most likely the starter ring gear on the flywheel is burred due to previous damage caused by the starter engaging while engine was running. I have corrected the ring gear from the starter hole with a three cornered file but not a pleasant job. Other option is to split tractor and replace ring gear. Make sure bendix fork in starter is not bent, broken or catching on something. Good Luck, DW

[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:26:22




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to WTW, 04-07-2009 08:44:21  
rite u r



[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:26:21




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to WTW, 04-07-2009 08:44:21  
rite u r



[Log in to Reply]  [No Email]
Handsome Jim

04-18-2009 14:26:20




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to WTW, 04-07-2009 08:44:21  
rite u r



[Log in to Reply]  [No Email]
jdemaris

04-07-2009 08:35:46




Report to Moderator
 Re: 24V JD 4020 diesel starter problems. in reply to IH 301, 04-07-2009 08:29:59  
Check the mechanical parts of the solenoid, contact disk and contact studs, pull-in linkage, etc. before worrying too much about the electric aspects. The 24 volt solenoid, mechanically, works just like the 12 volt setups. If the plunger sticks, or the contact ring sticks, it's going to keep cranking after you pull off the start-wire.



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy