My prior remarks aside, JR is welcome on this board or any other board in accord with the same rules of civility that apply to others. As for being sarcastic or mean, that comes form the heart, not from being misunderstood because of this medium. And so the board�s format can�t be blamed for a person simply being rude! JR must admit that he has danced around and used different handles form time to time, and that most likely was because he tends to get a little overheated at times and it always shows. The notion that for some reason folks on this board are jealous because JR�s Deere experience should stand for something great � well the notion is baseless, and yes � first-hand experience does count! By and large, I�ve observed that there many on the board who eagerly accept a turn at providing a help to someone in need. And yes, there are many times a question seems to be asked over and over. But consider this � such a question appears repetitive ONLY to those on the board everyday, and not necessarily to a simple folk asking it! I have to tell you also, that unless you are adept at searching the archives, answers there are hard to find � and it�s frankly more trouble than to simply ask again! And so for JR and a few others to chastise a poster for not researching the archives, is yet another form of sarcasm in my book. By the way, this is a main reason why I have a number of ARTICLES posted on the John Deere Model �H� website which are (or would be) my responses to many posts. I respond with simple instructions to the site, and then a few more notes for navigation directly to the information he needs. JR has made a lifetime commitment to put me down for listing my website in closing, but the forum leaders have no objection. I give far more than I take, and when the time arrives that I do not, I will be our of here, but I doubt I will make my departure a major event! John T. has a number of such articles �canned� and does a �cut-n-paste� as appropriate. You won�t see him griping that a question has been asked for the umpth time! And finally, there are a few (myself included) who have been known to come down on a fellow for trying to get all his answers here on the board. I have reconsidered my earlier response methods, and as of late refer such a fellow to a place where Deere pubs for his tractor can be determined, and for instructions for getting them. Those of us who have tried to �wing it� know that more damage can be done for the lack of instruction routinely found in a shop service manual and it�s probably natural to �go off� on someone, but here once again � teaching is a major element of the forum � demands patience! Bottom line � If your mission is to kick butt, find another BLOG to do it on, and should I become obnoxious, do not hesitate to point it out to me. But the way to get along on the forum is to stay on-topic and do not get personal. If you don�t like what you see, go for a walk � clears the mind. My two cents! (PatB)
|