|
Willy -- the John Deere Model H (JD-H) went into production beginning with the 1939 model year and basically through the 1946 model year. At least that was the plan. As things turned out, just over 2500 tractors were made during the 1947 model year, but are identical to their 1946 counterparts. Out in the field one should expect to find JD-H tractors numbered any where from 1104 up through 61116 with perhaps a small break just before 10,000. It is said that some 20% were exported which would leave some 52,000 of them sold in the US. To get a feel for the by-year production, you can check the YTmag website's serial number section. Many more probably would have sold had it not been for the Ford, and their tractors -- also targeting the small farm market. Actually, Ford sort of blew away the competition at the time for a number of reasons -- including that they were wife-friendly. Even the farm girls liked them because they were easy to drive, and besides -- in that era, girls generally didn't drive. Driving a tractor was fun! Back the the JD-H - - - Go to the JD-H Restoration Site (below) and see the BUYER'S GUIDE for this tractor. A JD-H tractor can be expensive to restore these days as are all JD tractors -- so scads of missing or wrecked parts on a tractor means MONEY will flow -- out of your pocket to make it whole again! As for what one should pay for a JD-H these days, that too varies. Many of them seem to have significant sentimental value. The owner may remember (romantically) the many hours he or she sat in the seat while the tractor struggled (hummed as they will recall). You notice I used the STRUGGLE word and that is because many bought the JD-H expecting it to do far more than it was capable of, and (by gosh) owners worked it anyway! As a result of this mental attitude, most JD-H tractors will show significant wear. I am building up a JD-HNH and just this last week picked up a near-full set of bearings & seals for which I paid close to $500, and to totally restore a 60 plus year old trctor and ignore conditions of the bearings is folly. And the very best pricing out there for just the parts to rebuild an engine is a $1000 bill. Sheet metal is precious. Grilles (used) will run $200 to $350 & after-market new @ $400+, Hoods are scarce and a really fine one can command between $600 & $800. And of course you know about tires & where they have gone lately. One note here -- old original tires are not to be ashamed of - I have a 1944 JD-HN tractor that took Best of Show last September on which is one of the original tires! So rubber is not a significant issue in judging a tractor's restoration! Now -- what should one pay? For a non-runner, anything over $1000 has to be based on fair tires, completeness and good serviceable or at least reparable sheet metal parts, and a loose (not stuck) engine. For tractors that are runners, the price could actually go down some -- depending on what the running tractor "tells you" -- but can a runner can range from $1000 upwards to several thousand depending on what has been done to the tractor. For any claim of expensive repairs having been made to the tractor which drive the price over $2000, I would ask for some receipts and or old parts (some evidence) to help you understand what really was done & to what extent. When & if you do buy that JD-H tractor, you will need the technical books available to help you know it inside & out. Be sure to explore the JD-H Restoration Site (below) for the best in guides to restoring that little gem. ALWAYS seek manuals from the seller when buying! If a seller claims to have made major repairs but lacks any of the three manuals for the tractor, I would have serious doubts here about anything he would have to say!!! Happy "H-ing". (PatB)
|