Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

John Deere Tractors Discussion Forum
:

3020 Diesel Hydraulic Problems

Welcome Guest, Log in or Register
Author 
SproutW

11-02-2006 20:09:26




Report to Moderator

Hope you guys can point me in the right direction. Our 3020 seems to have weak hydraulics. When we start it up it takes several minutes for the power steering, hydraulics and three point hitch to work. The hydraulics system seems to shutter and then will work ok. We have a loader attached and it seems real weak. I'm guessing the hydraulic pump needs rebuilt or replaced, but maybe it's something simplier and cheaper (wishful thinking maybe). Any ideas and costs. If I need to replace the hydraulic pump can I rebuild it myself or should I purchase one rebuilt? Also the hydraulics will start to shutter again from time to time even after start up. Thanks guys.

[Log in to Reply]   [No Email]
Chatermb

11-03-2006 13:55:55




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems in reply to SproutW, 11-02-2006 20:09:26  
Would the same fix apply to a JD 4000? My 4000 won't lift the loader for a few seconds after you start the engine then everything works fine. I took it into the dealership to get checked out and they said they could not find anything wrong.



[Log in to Reply]  [No Email]
Gerald J.

11-04-2006 13:45:11




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems in reply to Chatermb, 11-03-2006 13:55:55  
The 4000 is probably side console. The hydraulics are different and the check valve is drastically different in them. I have a collection of about 1968 to 1974 or so Deere tractor service bulletins. I recall in one or two of them there are comments about the side console tractors having the same effective failure as the check valve, but since my tractor is just before side console, I don't have that solution memorized or posted. And while some years are indexed, some are not so it takes a search through that 2" ring binder of bulletins to find the right ones. One has to be a bit careful in that era of service bulletins, sometimes a fix will have been printed then a couple months later, the fix was corrected so it really worked.

Finding out about the check valve for my 4020 took an old shop supervisor remembering it and finding the microfiche but they had no fiche printer so I made my scribbled notes that make up my web page. Today a printed version is available by the Service Information number but it has no figures, just the text. I don't know if service departments are good at searching for it or not. I know the SI I reference hasn't been well known amongst new generation tractor owners and it has taken rubbing in in the noses of some Deere shops to get it uncovered. I know my posts have fixed a number of tractors without me having to get dirty doing it.

Gerald J.

[Log in to Reply]  [No Email]
Tx Jim

11-03-2006 03:43:45




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems in reply to SproutW, 11-02-2006 20:09:26  
Sprout,Gerald is correct about the check-valve. Also I would get a gauge and check stand-by pressure on main pump. From factory it should be 2250 psi but one can nudge it to 2400 psi and that adds loader operation. If tractor is synco-range tranny then depressing clutch stops tranns. pump from pumping oil to main pump. Tx Jim



[Log in to Reply]  [No Email]
Gerald J.

11-02-2006 23:01:22




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems in reply to SproutW, 11-02-2006 20:09:26  
If its before side console, there's a check valve in the transmission that wears out and lets the oil reservoir up front dump back into the transmission. There is a fix converting an elbow to a valve. See my web page for that Service Information.

Gerald J.



[Log in to Reply]  [No Email]
SproutW

11-03-2006 11:56:53




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems in reply to Gerald J., 11-02-2006 23:01:22  
Does anyone have actual pictures of the valve when installed on the tractor. Just trying to make sure I have this straight before I screw up some elbow.



[Log in to Reply]  [No Email]
woodbutcher

11-03-2006 04:55:02




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems in reply to Gerald J., 11-02-2006 23:01:22  
Gerald,
I clicked on your link, but was unable to pull up your website. I have a 3010LP that seems to have the same problem. I was wondering where the elbow is on my tractor, and where I can get the valve to fix it.
Butch



[Log in to Reply]  [No Email]
SproutW

11-03-2006 05:33:05




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems in reply to woodbutcher, 11-03-2006 04:55:02  
I was also unable to load the web page. Our 3020 is has the hydraulic controls on the dash. It also has the synchronize tranny with the diff lock. I did notice a hydraulic leak on the front end. Which port on the pump should I hook up the pressure gauge? Does this 3020 have two pumps? Thanks guys.



[Log in to Reply]  [No Email]
Tx Jim

11-04-2006 04:30:58




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems in reply to SproutW, 11-03-2006 05:33:05  
Sprout just plug gauge in one of the break-away couplers on the rear and activate to read pressure. Tx Jim



[Log in to Reply]  [No Email]
Gerald J.

11-03-2006 08:06:43




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems. Link fixed in reply to SproutW, 11-03-2006 05:33:05  
I goofed. There should have been a .com in the url. http://www.geraldj.networkiowa.com/4020si.htm

It applies only to tractors with the SCV on the dash, not to side console tractors.

There are two pumps in these tractors. There's a charge pump in the transmission that also lubricates the transmission and the main pump up front. In between there is a check valve, a reservoir and a cooler. When the check valve wears out, the reservoir and cooler dump to the transmission and the high pressure pump runs dry.

It is possible to fix the original check valve but you have to lift off the rock shaft and cover. A few hundred pounds.

Deere sells the parts to convert the elbow to a check valve. The sales slip is one of the pictures on my web page with part numbers.

It takes a bit of drilling and tapping on that elbow to install the kit, plus a couple drops of loctite.

Before I put the fix on my 4020, it would loose hydraulics while shifting from a forward to reverse gear in the same range. After the fix, I can let it set a couple months, go push in the clutch, start the engine, and then lift the loader before I let the transmission turn at all. Its working.

Gerald J.

[Log in to Reply]  [No Email]
WTW

11-03-2006 10:23:41




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems. Link fixed in reply to Gerald J., 11-03-2006 08:06:43  
Gerald, Here is an update to the information you have on your website. The R39075 seat replaced by R68553 is now replace by an AL71016 kit. This kit also includes the R39076 guide and R39078 spring. The D2361R ball is not included in this kit. So to get all the parts needed to perform the task at hand all you will need to get from your John Deere dealer is a AL71016 kit and a D2361R ball. Then just follow your instructions as you have posted. Good information. Thank You, DW

[Log in to Reply]  [No Email]
Gerald J.

11-03-2006 14:11:21




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems. Link fixed in reply to WTW, 11-03-2006 10:23:41  
If you don't mind, I'll update my web page with your information.

Gerald J.



[Log in to Reply]  [No Email]
Nylon

11-03-2006 16:50:47




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems. Link fixed in reply to Gerald J., 11-03-2006 14:11:21  
Would be great if you would update your page with the info. II will have to make that fix before too long. Just haven't got a chance to yet. Thanks to WTW on the update #s too.



[Log in to Reply]  [No Email]
Gerald J.

11-06-2006 15:53:06




Report to Moderator
 Re: 3020 Diesel Hydraulic Problems. Link fixed in reply to Nylon, 11-03-2006 16:50:47  
I have visited the local Deere shop with a parts computer.

It says the AL71016 kit (broken out on the 840 tractor parts pages) includes the ball, the seat, the spring, and the guide plus an O-ring. It doesn't include the machined elbow. I wasn't able to tell if Deere has a part number for the machined elbow. The kit is used on 129 tractors, mostly of European origin. Up through at least the 2355.

I have updated my web page in the last hour.

Gerald J.

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy