Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

John Deere Tractors Discussion Forum
:

60 dies when hot durring work out

Welcome Guest, Log in or Register
Author 
Fred from MO

03-11-2006 01:26:30




Report to Moderator

Grading a road for an hour or so yesterday the 60 acted if it was running out of gas, started sputtering then died. She started right back up fine and would idle, but when put in any gear she would die immediatly. Checked the basics, gas was good, so I let her cool down for 20 min and she ran fin again. Coil felt hot to the touch. Any clues? Again only when in gear she would die. I could only go a couple of feet at a time.

[Log in to Reply]   [No Email]
F-I-T

03-11-2006 17:56:15




Report to Moderator
 Re: 60 dies when hot durring work out in reply to Fred from MO, 03-11-2006 01:26:30  
Fred:

I think it is ignition related, but given the oil-pressure controlled fuel shut-off system that can be present on a '60', you could have probable cause to expect a problem from either system.

In cases like this, the first thing I do is to make sure there a pencil sized stream of fuel from the bowl drain for 30 seconds before anything else. If normal, I hook a timing light to the plug wire and start working the engine, and if the light cuts out just when the engine sputters, you have an ignition problem. If she sparks right to the bitter end, it's fuel related.

But check out your coil and see if you have a 6 volt coil and the necessary dropping resistor, or do you have a 12 volt coil with internal resistor, or do you have a 12 volt coil that is running on 12 volts plain.

Frank

[Log in to Reply]  [No Email]
B-maniac

03-11-2006 14:16:55




Report to Moderator
 Re: 60 dies when hot durring work out in reply to Fred from MO, 03-11-2006 01:26:30  
If it "started right back fine but would only idle" I would have to agree with the one post that suggested fuel percolation from heated fuel line. I believe if it was electrical,it wouldn't start right back up after dieing.Maybe wrong,been there before.



[Log in to Reply]  [No Email]
Glen in TX

03-11-2006 08:55:29




Report to Moderator
 Re: 60 dies when hot durring work out in reply to Fred from MO, 03-11-2006 01:26:30  
Coil and condenser like others said but also check wires to and from the coil and distributor. Are you running a ballast resistor and is your coil the type that needs one?



[Log in to Reply]  [No Email]
billonthefarm

03-11-2006 05:53:55




Report to Moderator
 Re: 60 dies when hot durring work out in reply to Fred from MO, 03-11-2006 01:26:30  
fred It is easiest to start with the condensor and if that doesnt work try the coil. Have had this same thing happen a coulple times and the condesor was the problem both times. I still have one of those failed condensors hanging up so I dont forget to start with the easiest things first. bill



[Log in to Reply]  [No Email]
dennis cotton

03-11-2006 04:21:31




Report to Moderator
 Re: 60 dies when hot durring work out in reply to Fred from MO, 03-11-2006 01:26:30  
I had the same problem with my 70 gas at one point.. It did the same, after a good work out it would die, as it cooled it would come back.. I found that with the fuel line over the years was pushed over the exhuast manifold and would then get heated causing a vapor lock in the fuel line.. To test it i wrapped it with wet rags and later made a new one to avoid going over the mainfold..

Dennis



[Log in to Reply]  [No Email]
Mike M

03-11-2006 04:17:47




Report to Moderator
 Re: 60 dies when hot durring work out in reply to Fred from MO, 03-11-2006 01:26:30  
I have always been told that quitting when hot was what coils do when they fail. Condensers will also do this.



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy