Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

John Deere Tractors Discussion Forum
:

1950- G- RING GEAR

Welcome Guest, Log in or Register
Author 
LUKE ERPELDING

01-19-2005 16:57:31




Report to Moderator

CAN THE STARTER RING GEAR BE TURNED AROUND HAVE A FEW TEETH THAT ARE BAD.




[Log in to Reply]   [No Email]
Clooney

01-19-2005 17:07:18




Report to Moderator
 Re: 1950- G- RING GEAR in reply to LUKE ERPELDING, 01-19-2005 16:57:31  
Luke, sure you can pull the ring gear & flip it..(I've done many)


Just pull the flywheel,,, then run a torch around the ring to heat & expand it,,, then drive it of with a brass drift..

Once off, re-heat it & drive it back on flipped over.. Then you will have to take a grinder & re-grind the tooth chamfer on the teeth so the starter engages correctly..

If the ring teeth aren�t too awful bad you can just heat the ring gear & rotate it about 90�,,, those 2- cylinder engines usually only stop in 2 places (that is why the teeth only wear in a couple of places to begin with).. Usually just rotating the gear 90� will stop the grinding if the teeth are not completely worn out..

On regrinding the tooth chamfer.. Just get close to matching the good teeth on the original side..

Clooney

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy