Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

John Deere Tractors Discussion Forum
:

1963 JD 2010 - Any Thoughts Good or Bad?

Welcome Guest, Log in or Register
Author 
Yes Deere

01-05-2005 19:54:32




Report to Moderator

I've heard the 1010's were bad but what about the 2010's? I've recently learnd that a friend has one that has been sitting for ~10 years. Looks like it shouldn't need much since it has been stored inside. Carb cleaned, new gas, battery, and water in radiator should get it started. Are these dependable tractors or junk? It has good rubber, 3 point and excellent tin any thoughts on an approximate value? Thanks for any responses.

[Log in to Reply]   [No Email]
Loren NC

01-06-2005 15:20:35




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
I have a 1010 so have asked my dealer a lot of questions about them. He says the only thing worse than either a 1010 or 2010 gas is either one of them in diesel. However, forced to make a choice, he would always take a 1010 over a 2010. The first thing he tells me when I go for parts is that from the beginning a lot of parts were not available and it isn't getting any better. So far he has still had what I have needed. However, he refuses to work on the hydraulic system.

[Log in to Reply]  [No Email]
steveVT

01-11-2005 11:33:46




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Loren NC, 01-06-2005 15:20:35  
i've owned a 2010 for about six years or so, and given how badly it was obviously treated by its previous owner, i'm surprised at how reliable it has been. oddly, i'm gratified to hear that your dealer refuses to work on the hydraulics since mine have been a constant source of problem since day one. my problem seem to lie in the rockshaft valve and i'm rebuilding a single unit to replace the dual unit originally in the tractor. maybe i'll get lucky and this one will function properly. in a previous job i found someone in south africa parting out a 2010 so i stocked up on parts .... i'm hoping my inventory will outlast my tractor's hydraulics stubborness in refusing to work right.

[Log in to Reply]  [No Email]
Ben.So.Tex

01-06-2005 11:49:47




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
If it is a diesel, TRASH it. My 2 pennies



[Log in to Reply]  [No Email]
Mike M

01-06-2005 10:04:07




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
You may get lucky ?But if you would step up to something like a 1020,2020,3010,4010,2510 you would not have any regrets and be the envey of us all.



[Log in to Reply]  [No Email]
Bob

01-06-2005 07:54:46




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
In my opinion, the BADNESS of the 2010's is, in most cases, highly OVERATED.

I know of a couple still in use, and as a matter of fact, I do service work on one of them that's still used all summer in the hayfield.

That is an early Diesel, and it just keeps chugging along.

They're a bit cold-blooded and not as refined as later tractors, but I think they're OK for their age.

Most parts are still available, but of course, like everything else, they're pricey.

The sleeve decks ARE still available.

[Log in to Reply]  [No Email]
Walter Squires

01-06-2005 07:14:50




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
About 2 or 3 weeks ago I asked the question on the Tractor Talk Discussion Board "Whats The Worst Tractor Ever Built" the first one was a Ford 6000 Comander, the second was a John Deere 2010.
Good Luck, Walter



[Log in to Reply]  [No Email]
rick in sc

01-06-2005 04:02:42




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
Parts avilibility for the 2010 is not as good as other Deeres.They don't have good brakes either.Basicly the same as the early Dubuques,but trying to stop a much heavier tractor.Gas engine pretty reliable;early diesel noted for hard starting and short life.I don't think the sleeve deck for either engine is still avalible,but not sure.They are also noted for hydralic problems.They seem to be of dual nature too as I once read that you counld'nt tear up a good 2010 and you counld'nt fix a bad one.

[Log in to Reply]  [No Email]
buickanddeere

01-06-2005 06:39:16




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to rick in sc, 01-06-2005 04:02:42  
The 1010 used the same/similar brakes as a 40/420/430/320/330/435/440.



[Log in to Reply]  [No Email]
buickanddeere

01-05-2005 21:52:23




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
Any gas 1010 was fine. Even the diesels were ok if not abused and taken care of. It was the early diesel 2010 that was the mistake.



[Log in to Reply]  [No Email]
CLW

01-05-2005 21:18:54




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
Some folks like them and have had good luck with them, others have had all kinds of trouble with them. I have never been around one so I don't know. I did read in 2-Cyl. or GM an artical once that said "the 4020 was the best tractor Deere ever built and the 2010 was the worse". Could have been an unhappy 2010 owner that wrote the artical.
CLW



[Log in to Reply]  [No Email]
Dan50

01-05-2005 20:07:56




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Yes Deere, 01-05-2005 19:54:32  
They don't have a good reputation - sorry. Try a search on this forum or read the 4 part story that you can navigate to by starting on the left side of this page. Click on Articles under Research & Info. Then scroll down to the heading Restoration Stories. Look down and read the 4 part story on one man's journey restoring a 2010. Pretty interesting with pictures and everything.

-Dan



[Log in to Reply]  [No Email]
john werner

01-08-2005 15:11:25




Report to Moderator
 Re: 1963 JD 2010 - Any Thoughts Good or Bad? in reply to Dan50, 01-05-2005 20:07:56  
STAY AWAY from 2010's. I owned one and had a head gasket failure and if you replace the gasket under the "liner plate" you have to completely teardown the engine--- taking pistons and rods out--- then you have to carefully put the "liner plate" back in without cutting o-rings on bottom of all four liners-- which must all go in at once. There's a reason JD only produced this engine for two years!!!!!

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy