Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

John Deere Tractors Discussion Forum
:

Electrolysis Explosion!

Welcome Guest, Log in or Register
Author 
Brandon

10-06-2003 18:42:19




Report to Moderator

This was posted on the John Deere ATIS list by someone else, and I thought it might be of some interest to some of you...something to watch out for!

"Mornin' all;

Just thought I'd let the other side of the tracks know what happened yesterday. I had a pretty good explosion as one of the cable leads must have thrown a spark. It was a pretty good report similiar to a M-80. This is a picture I took just prior to the event.

Link

Not what I considered a closed area..as it was in the shop door opening. A young girl who I hadn't noticed showed up and must have bumped a lead. She's deaf and can't talk, but sure she felt the concussion, and wore a little of the foam. She's fine.

Very thankful I was not using lye or Drano..Washing Soda is harmless, but it does stain and works fantastic!!

Bottom line is not too move the leads without turning the charger off first."

After some discussion on the list, it is pretty much agreed that this was caused by a buildup of hydrogen gas from the electrolysis.

Brandon

[Log in to Reply]   [No Email]
Ralph-The Chemist?

10-06-2003 19:47:47




Report to Moderator
 Re: Electrolysis Explosion! in reply to Brandon, 10-06-2003 18:42:19  
I have been scratching my head about electrolysis since before reading about it here. Washing soda is what I would call a mild caustic (that's why it is used for washing). However, I would not call it harmless (i.e. eyes or left on my skin). From your comments I suspect the major reactions are not the redeposition of any metal, but the liberation of gases (hydrogen at the cathode(-)and oxygen at the anode(+)). These gases will most likely liberated right at the (metal electrode)/(aqueous electrolyte) interface. The electrolyte will become more caustic (better cleaning)in the region of the cathode and less caustic in the region of the anode. The large increase in volume on the transformation from a liquid to a gas causing the oxide and other foreign material to flake off. The M-80 analogy suggests that it was indeed a hydrogen-oxygen explosion, most likely tempered with an unknown amount of air. I once felt the need to demonstrate the burning of a hydrogen filled ballon to my class as well as other ballons filled with the same amount of hydrogen and either air or pure oxygen. The pure hydrogen burns quickly, the hydrogen mixed with the required amount of air (only 21% oxygen) shall we say "explodes" i.e. very fast burning. After setting off the ballon filled with hydrogen and pure oxygen I never felt the need, nor did I perform the demonstration again. I you are going to clean with electrolysis, Wear Goggles and skin protection!! . Isolate the site from intruders (children, animals, freshly painted tractors, wrenches etc.) of any variety.

[Log in to Reply]  [No Email]
F-I-T

10-06-2003 19:44:37




Report to Moderator
 Re: Electrolysis Explosion! in reply to Brandon, 10-06-2003 18:42:19  
Sure it was the hydrogen. Something like this should ALWAYS be operated in a well ventilated area....just like no smoking right after cleaning the paint gun with lacquer thinner.

The foam on the water has two kinds of bubbles....around one electrode is oxygen and around the other is hydrogen. That's what electrolysis means.

I make my tank pop all the time when I run my metal cutting chop saw and throw sparks near it. It's pretty antgi-climactic. Lot less noisy that if my torch pops. I'd be pretty surprised if it sounded like an M-80. Hoping he didn't have any type of cover over it, because that would be a no-no.

Put the tank outside, and keep pets and small children away. I do lose several frogs a week in my tank, sad to say.

F-I-T

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy