|
| |
Front end gaskets on B
| Author |
|
|
steve c
08-12-2001 05:24:30
|
Does anyone know where I can get the gaskets that go in the frontend of a 41 B. I figured that I might as well replace them while I got it apart this far. Thanks
|
|
|
|
Dave G
08-14-2001 10:58:55
|
|
Re: front end gaskets on B in reply to steve c , 08-12-2001 05:24:30
|
|
| |
Your Case IH dealer will have them. Be prepared to press some tough bearings off up in the steering housing in order to get to the steering gear seal. It is hard to do but worth doing if you want to hold oil up there.
|
|
|
|
big fred
08-12-2001 10:45:21
|
|
Re: front end gaskets on B in reply to steve c , 08-12-2001 05:24:30
|
|
| |
I got all the gaskets for my B from my Case/IH parts dealer. For the steering gearbox I think there were two gaskets and an oil seal, for the front axle there were hubcap gaskets, a grease seal and a felt washer.
|
|
|
|
Dave T
08-12-2001 09:48:59
|
|
Re: front end gaskets on B in reply to steve c , 08-12-2001 05:24:30
|
|
| |
If you are talking the front cover off the motor, then you can get from your Case/IH dealer
|
|
|
|
steve c
08-12-2001 17:06:24
|
|
Re: Re: front end gaskets on B in reply to Dave T, 08-12-2001 09:48:59
|
|
| |
I was looking for the gaskets for the front end . Steering gear etc. Thanks.
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
need 3 point arms (with the ball) especially need the
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
