Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Attention Forum Users: On the 28th of December 2023 at 9:00am Central Time, we will be taking the forums down for maintenance while we prepare the new forums for your use. Please click here for more information.

Case Tractors Discussion Forum
:

Spark Plugs Still Black

Welcome Guest, Log in or Register
Author 
Kestrel

03-25-2006 17:51:05




Report to Moderator

I just completed a valve job, general tune up, plug wires, timing, carb rebuild, etc. on my 1956 Case VAI. She runs great now but the spark plugs still show the same condition as before the overhaul.

All plugs still have fairly moderate to heavy carbon except # 2 cylinder which is a nice dry tan color. Again, this was basically the same pattern as before the overhaul.

But compression is good and uniform now with approx. 85-90lbs each cylinder and no blue smoke or backfires as before. Spark appears good for each cylinder.

My question is: do these Case engines run with a hot cylinder, specifically #2, as compared to the other cylinders ? Maybe carbon build-up is normal for these 4 bangers.

I remember the late '60s and '70s VWs had trouble with #3 exhaust valve burning unless it was opened a little.

Only thing I didn't change was the dist.cap.

Any thoughts appreciated.
Kestrel in CT.

[Log in to Reply]   [No Email]
Kestrel

03-26-2006 05:51:03




Report to Moderator
 Re: Spark Plugs Still Black in reply to Kestrel, 03-25-2006 17:51:05  

Joe,
Thanks. Yes. I checked for ring leakage before and after all this and there was no discernable difference so I limited the work to just the head, etc.

She doesn't like 4th gear unless its perfectly level. I don't have much wheel time with her, just trying to get everthing working and cleaned up. Bought her in rough shape but has a nice original Wagnor loader I plan to put to work.

I'll try the Autolite plugs though and give her some wide open throttle on the road. Yours has great compression-jealous here.
Kestrel

[Log in to Reply]  [No Email]
Joe (Wa)

03-26-2006 21:31:26




Report to Moderator
 Re: Spark Plugs Still Black in reply to Kestrel, 03-26-2006 05:51:03  
I think you have a good handle on what you need to be looking for, gas/air mixture-timing-etc. Low engine running temp will also foul plugs, T-stat ok?

'56 VAI will likely have road a gear in 4th, something close to 35 mph, pretty tall gears for a small engine pushing 3000-3500 lbs. My '53 VAC has that road gear, lots of grunting upgrade, easy 35 mph on the level, down shift to 3rd down hill(no stones LOL).

Joe

[Log in to Reply]  [No Email]
Joe (Wa)

03-25-2006 21:22:16




Report to Moderator
 Re: Spark Plugs Still Black in reply to Kestrel, 03-25-2006 17:51:05  
You probably already know how to check for ring leakage but if not:

Take a compression reading on a cylinder and note the pressure. Dump a tablespoon or so of oil in the cylinder and wait a few minutes for the oil to spread down on the rings. Take another reading, if the pressure goes up the rings are leaking.

Joe



[Log in to Reply]  [No Email]
Joe (Wa)

03-25-2006 21:12:38




Report to Moderator
 Re: Spark Plugs Still Black in reply to Kestrel, 03-25-2006 17:51:05  
Cranking compression 85-90 psi is not bad but a little on the low end. Service manual compression is considered normal @ 95-105 psi with a spread of 5 psi or less on a fully charged battery (cranking speed about 150 rpm).

Your rings may be leaking some, you might want to try working the snot out of the engine to try to get a better seating.

My Vac averages 108-110 psi on a well worn engine. When I do a lot of low load and idling, the #3 & 4 plug tend to fowl. I switched from Champion D16 to Autolite 386 and get much longer service out of the plugs.

Joe

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy