|
| |
| Case Tractors Discussion Forum |
4 1/16 sleeves for a D series
| Author |
|
|
dboll
07-02-2007 12:38:57
|
Hi all, I have 4 used comformatic GE 271 pistons, looking for 4 sleeves, new or used otherwise I will have 4 used ones bored out to 4 1/16
|
|
|
|
C. Amick
07-03-2007 19:01:20
|
|
Re: 4 1/16 sleeves for a D series in reply to dboll, 07-02-2007 12:38:57
|
|
| |
Try John Saeli at jsaeli@rochester.rr.com or 315-585-9826.
|
|
|
|
wilson
07-02-2007 15:18:08
|
|
Re: 4 1/16 sleeves for a D series in reply to dboll, 07-02-2007 12:38:57
|
|
| |
I have a new set of rings for ge confordmatic as other 4&1/16 will not fit same as say M&W I will take $100.00 for set including shipping
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
combine ih 303 403 101 151 503 615 with grain plat header control
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
