| |
Case Tractors Discussion Forum |
2670 redo?
Author |
|
kirk in ks,
07-06-2006 19:01:18
|
I wanna get the A/C going in my 2670, I saw a little fuse panel in front of the panel behind windshield, is that the fuses to the A/C,and A/C clutch? I need the vinyl tube,s to the drain,s on side,s of upper panel where knob,s and control,s are, some of the knob,s are stiff, do i use WD-40 on them to free them? Can I still get the original outside body decal,s? Found out the tightner knob,s for window,s and door,s arnt cheap,13,00 a piece,so Ill wait on them for now, seat is stiff, so Ill shoot it with some wd-40 to loosen it up, have throttle , and shutoof cabl,s, But hesitating to put them in as it look,s like kind of a job, Other than that,im trying to clean it up,and make it look halfway decent. K,C,
|
|
|
c hess
07-08-2006 12:31:51
|
Re: 2670 redo? in reply to kirk in ks,, 07-06-2006 19:01:18
|
|
Use wd40 on knobs- can get vinal tubing at Ace Hardware- If shifter knobs are loose use JB Weld to reset them. You can get origional cab covering from Fehr Co in Ill, I believe rims were Case aluminium painted .Air cond has aHI AN LOW PRESSURE safety ON IT .You might get lucky an just need freon. By pass them an see if compressor will run for quick check. Sounds like it will be sharp when you are done. 1470 just couple miles away from me for sale sure wwould look sharp. Only has 1300 hrson it but guess i will dreamabout it.
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
Latest Ad:
M 5 moline.. 336, good TA , 16-9 38 tires..fresh paint PS photos on request....nice 3 point tractor with strong hydraulics new battery and service
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|