Re: Allis Frontend Loader in reply to Carl, 09-28-2002 04:44:10
New Idea sold loaders than fit D17's. It think the model # might have been 500. Currently Westendorf sells the TA26 with D17 mounts, but it has a hydraulic dump bucket,so it needs 2 double acting hyd circuits which D17's did not have until Series 4. If yours is an earlier D17, you need a trip bucket type loader,like the AC or NewIdea. There is a used equipment dealer in Pomeroy IA that has a lot of this type of thing, you could try him at 712 468 2522 between 7-9 AM Central
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
John Deere Tires And Rims, (1) Set Of Duals, Axle Mounting Hubs, Tire Size 18.4-38, Units Are Off Of A John Deere 4440 Tractor, Year Is Unknown
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.