| |
AC model M steering clutches
Author |
|
skip
02-13-2002 18:42:13
|
Anybody know how to free up steering clutches without dismantling?
|
|
|
Ted V
02-14-2002 17:39:48
|
Re: AC model M steering clutches in reply to skip, 02-13-2002 18:42:13
|
|
I just went through this on a 1940 WM. If you can't compress the springs at all, the steel discs may have rusted and scaled to the point where the clutch pack has "grown" and now takes up all the space leaving none to release the clutch. My clutch pack had grown 5/8". I had to remove the final drive unit to get at it which also means dropping the track,track frame from pivot bracket, then pivot the bracket up or down far enough so that the sprocket will clear. As rusty and scaled as they were, the steel and the fiber discs cleaned up with chipping, scraping and a pass over the belt sander to be reused. Ted
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
16 x 38 double bevel rims, sealed and painted 250 each
[More Ads]
Copyright © 1997-2022 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|