|Allis Chalmers Discussion Forum|
allis chalmers loader tl-12
[Return to Forum]
[Log in to Reply]
This message is a reply to an archived post by Patrick Willis on May 28, 2006 at 17:26:55.
The original subject was "allis chalmers loader tl12".
I don't know where to find parts, as thats what I'm after too, (although we've got a parts machine, so if there is something in particular I could see if I've got one), and I don't know how to adjust the tranny but I do know the stats. Its a 12,000 lb machine that uses as standard a 1- 1 1/4 yard bucket, and it can lift 4000lbs to a height of 121inches (according to my manual). I'll look in it about how to adjust the tranny so I'll keep you updated on that
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
IHC McCormick Deering WD-40. WDC-516. Engine also is serial number WDC516. Vertical injector head. On rubber. Round spoke rims. Starts and runs nice.
| Copyright © 1997-2021 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy