|
Allis-Chalmers Discussion Board |
Re: Re: NAPA 1101 Oil Filter
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by steve on July 13, 2003 at 05:56:08 from (204.246.222.105):
In Reply to: Re: NAPA 1101 Oil Filter posted by AC in MI. on July 12, 2003 at 20:34:01:
if you install a full flow filter or remove the 1/4 inch tube from the filter, you will get 50%of the flow thru the filter to sump and not 15%. this will result in the internal pressure dropping well below 14 psi, possibly down to 5-6 psi. The internal relief at 15 psi will never open with reduced flow to it. This can definitly cause problems with the crank and rod bearings. The gauge is in the wrong place, but it does give a good indication of what is going on.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
