Posted by PJH on December 12, 2010 at 08:51:13 from (72.69.92.117):
In Reply to: Snow sifting into shed posted by Moline_guy on December 11, 2010 at 16:29:00:
In my old home built machine shed, I used the 4' foam water pipe insulation. It wedges into the gap between the ends of the roofing metal and under the ridge cap. It's held up good for several years now.
In another building, the ends of the roofing metal were too far apart, and I used strips of 1" thick closed cell foam nailed to the bottom of the purlins. Purlins on that building lay flat. Don't really like that idea, cause the snow probably still gets in onto the top of the foam, but it seems to be causing no problem. So far.
I'm kinda disappointed in the foam that fits the contour of the roof metal. Some of it stays in place - some of it don't. Might be my fault for installing it wrong?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.