Posted by LOU from Wi. on November 06, 2010 at 18:08:51 from (174.124.102.65):
If you recall, a while back i was asking for fellows who have been indide a 722 for information on the internal parts problems they may have had. Ours quit with a bang and locked up R.F. side. Pictures will show just why it failed.Bearings, bolts, frame wear. shaft insert someone installed ,Gear busted into,with many parts left in the tank. Son is gonna remedy the whole situation with new parts, welding old frame gear holder,Run a magnet throught the bottom of the tank to remove shavings, bearings etc. Now if this unit wasn"t so badly needed to load our winters wood supply on the truck, then we could put the 706 into play. However the tractor is much slower then the Bobcat i.e bucket lift, tilt, clearance on the truck side for loading.My son pulled the L.S.panell off, and made an inspection of the good side of the bobcat, All is WELL there. No Major wear indicators on any of the sprockets,chains,frame assembly.We are going to F&F for a master link for the chain (that will make 2 M.Links on that side. More is better???? lol.Well Now that the unit is in the repair mode, (after the right side is repaired)its on to the left rear seal that has been Slowly leaking oil for a little while. Gonna stop the leak. Well ,if you ever need to know the internal workings of a old 722 Bobcat. Hopefully we will be around to give a small amount of advice. Here"s the pictures.Oh Yes,ps, were going to change hyd filters.just forgoing the question on changing filters. lol.Warmest reguards, LOU & Victor
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.