Tractor Talk Discussion Board |
Re: Front Axle pivot pin removal ??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by m.kennamer on February 18, 2001 at 09:50:39 from (63.108.130.27):
In Reply to: Front Axle pivot pin removal ?? posted by Bob LaBrie on February 18, 2001 at 07:37:20:
hi am in the process of doing the same thing to my 1952 ford 8n .i am using a slide hammer and mine is frozen also .i am doing this with my complete front axil still intact with just the front wheels removed. in my case there is probibly to much weight on the pivot pin.i have jack stands under my axil tightly so when i did manage to remove the pin the axil would not drop.i should probibly remove the left and right axil extension so the only thing still hanging is the center axil .with less weight on the pivot pin i am hoping i can remove it.good luck to you on your pin removal.if you receive any good ideals please e-mail them to me .Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|