Posted by Tx Jim on October 29, 2009 at 03:45:28 from (67.142.163.34):
In Reply to: o/t gate hinges posted by DaveK(IN) on October 28, 2009 at 20:34:32:
TimMiller
I've had an electric operated gate for over 10 yrs. I have ball brg hinges on it. I bought my hinges on the internet,. One drawback is no adjustments to level gate. I started out with a Mighty-Mule gate opener but now I have an Apollo. Mighty-Mules aren't built near as strong as Apollo's.
Another thing to consider when building a gate is wind blowing against it making load heavier.
If one has adequate gate posts a wheel isn't necessary. A wheel would also increase load.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.